Zeong Bear Chapter 2

PREVIOUS CHAPTER

I'm making decent progress on certain areas as far as modding goes. I got some nice piping detail on the fuel tanks. It was as easy as stabbing a hole in the sharpie and then inserting some pla tubes.


I did some more Armor Trimming on the forearms too. Still need to clean it up a bit but yo uget the idea.


I also started another little project too. Can you guess what these are going to be?


If you guessed scratch built back pack you are correct. I'm only going to show little bits here and there of the back pack build cause for one I'm not sure if I'll get it done and two, I'd like to make a tutorial from it once the project is done. I got a lot of inspiration and ideas from a blogger named Funakatown who has some great scratch built stuff: FUNAKATOWN. Here's something to give you an idea of what it will look like.


Although it's a bit ambitious for me, I also started working on bettering the articulation in the torso. Hopefully with what I do, it should be able to turn and lean from side to side. Because I'm not afraid to use parts from my other models, I tore the ankle of the 00 Raiser apart and that is what will be used for the motion. Then I cut some strips from the black part so the mounts could fit and the black part could come out for painting and such.


Lastly, I started to look at paints and settled on three. They're pretty simple, plus I have some left over grey paint from the Z2 Zabanya to use too.


Thanks for dropping by!


NEXT CHAPTER